5 Basic Points For Operating Explosion-Proof Electric Locomotives

1. The locomotive runs first, and its gears should follow the shift from low gears to high gears. At this time, it is necessary to pay attention to the clutch pedal during each gear shift, and respond to increasing the throttle. It is strictly forbidden to suddenly change the throttle, and remember , Do not step on the clutch pedal with your feet, excessive wear on the clutch friction plate.

2. The driving staff must establish a high sense of responsibility and enhance awareness of themselves and his tranquility. If the electric locomotive encounters a reverse gear or a reverse gear in the running gear, the explosion-proof electric locomotive must be stopped before it is replaced, otherwise the gears in the gearbox will be damaged. Pay attention to cooperating with the actions of the miners and the workers who turn the miners outside to ensure that they are quiet. When the underground mining locomotive is running, when it encounters a bend or a bifurcation, it must be slowed down, then turn the switch, and the electric locomotive will pass the bend or turnout After that, turn the switch back to its original position.

3. Every shift of the clutch bearing needs to be smoothed once (waste engine oil is enough). The tensioner adds lubricating oil to the bearing once every half a month; the underground mining locomotive chain is checked and smoothed once every 5 days, and the throttle cable needs to be smooth every shift Once; the hyperbolic gear oil in the gearbox is checked every 10 days to see if the oil scale is between the two scale lines. In the absence of real-time refueling, the gearbox is replaced every six months.

4. Discharge the carbon deposits in the explosion-proof water tank every shift, and eliminate the blocking time of the anti-fence above the exhaust port; change the water in the explosion-proof water tank every three days; wash the explosion-proof fence of the exhaust port once a week; every 20 —Wash and replace the engine oil once every 25 days; wash the explosion-proof barrier of the air inlet once a month; wash the air filter once every 15 days; Foot grease gives the bearings on the four large steel wheels once, extending the service life.

5. Before starting the diesel engine, first check whether the engine oil is within the approved scale of the engine oil scale; whether the water in the water tank is full (the water source is added every two hours); whether the water in the explosion-proof water tank is full and clean , And make up and replace at any time. After starting, do not drive the car immediately, let the diesel engine rotate for about five minutes, and listen to whether there is any abnormal sound. Otherwise, check and remove the problem in real time.